RADVision SCOPIA 400 Guide de l'utilisateur télécharger pdf (Page 66)

56 SCOPIA 400/1000 Gateway User Guide

Connecting the Gateway to a Power Source

SIGNALING INTERFACE

IN LAYOUT

This section illustrates the pin layout for the Serial Gateway signaling cable

connector.

DB-25 C

ONNECTOR Figure 2-19 shows the DB-25 pin layout.

Figure 2-19 DB-25 Pin Layout

CONNECTING THE

ATEWAY TO A

OWER SOURCE

This section describes how to supply power to the Gateway. The Gateway is

equipped with an autoswitching power supply that supports 100-240 VAC at

50/60 Hz.

 Procedure

1 Plug a power cord into the power socket on the rear panel of

the Gateway.

2 Connect the power cable to a grounded AC outlet.

3 Turn the power on.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 207 208

Pas de commentaire

RADVision SCOPIA 400 Guide de l'utilisateur Page 66