RADVision SCOPIA 400 Guide de l'utilisateur télécharger pdf (Page 42)

32 SCOPIA 400/1000 Gateway User Guide

Installing the Gateway

8 Snap the handles forward to secure the Gateway module in the

slot.

9 Secure the Gateway module screws.

Caution Blank faceplates and cover panels serve three important functions:

they prevent exposure to hazardous voltages and currents inside the chassis;

they contain electromagnetic interference (EMI) that might disrupt other

equipment; and they direct the flow of cooling air through the chassis. Do not

operate the system unless all blades, faceplates, front covers, and rear covers

are in place.

REMOVING A MODULE This section describes how to remove the SCOPIA Gateway or the RTM module

from the SCOPIA 400 chassis and from the SCOPIA 1000 chassis.

Warning You must remove the Gateway module from the slot at the front of the

chassis before removing the corresponding RTM module from the same slot

position at the rear of the chassis.

 Procedure

1 Loosen the Gateway or RTM module screws.

2 Press the red buttons and open the handles of the Gateway or

RTM module (see Figure 2-6 for the SCOPIA 400 chassis).

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 207 208

Pas de commentaire

RADVision SCOPIA 400 Guide de l'utilisateur Page 42