RADVision SCOPIA 400 Guide de l'utilisateur télécharger pdf (Page 121)

Configuring the SCOPIA Gateway 111

Configuring Gateway Settings

5 If you selected Independent at step 4, you need to assign a mode of

operation to each call leg, as follows:

In the ISDN (H.320) Mode and IP (H.323) Mode or Serial (H.320) Mode

fields, choose one of the following settings:

 No Encryption—Encryption support is disabled.

 Best Effort—The Gateway implements a “best effort” encryption

algorithm. If an endpoint supports encryption, it connects in an

encrypted way. If not, it connects without encryption.

 Encryption Required—The Gateway connects only AES 128

encrypted calls.

6 Click Upload.

CONFIGURING

ADVANCED

SETTINGS

In the Advanced section of the Settings tab, you can configure, enable, and

disable various advanced Gateway settings.

 Procedure

1 In the Gateway interface, on the sidebar, click Gateway (if not already

selected).

2 Click the Settings tab.

3 Click Advanced.

Table 3-12 explains the IP-to-ISDN (or Serial) call settings you can

configure in this section.

Table 3-13 explains the ISDN (or Serial)-to-IP call settings you can

configure in this section.

Table 3-14 explains the IP call settings you can configure in this section.

Table 3-15 explains the ISDN call settings you can configure in this

section

(available in PRI Gateways only).

Table 3-16 explains the general call settings you can configure in this

section.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 207 208

Pas de commentaire

RADVision SCOPIA 400 Guide de l'utilisateur Page 121