RADVision SCOPIA 400 Guide de l'utilisateur Page 129
- Page / 208
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Configuring the SCOPIA Gateway 119
Configuring Gateway Settings
ABOUT DTMF
DETECTION ON ISDN
OR SERIAL-TO-IP
CALLS
The Gateway passes incoming in-band DTMF signals to the IP-side endpoint
unchanged. In addition, you can configure the Gateway to convert in-band
DTMF signals from the ISDN or serial side to H.245 out-of-band signals on the
IP side. Figure 3-3 illustrates ISDN or serial-to-IP DTMF processing.
Figure 3-3 ISDN or Serial-to-IP DTMF Processing
CONFIGURING DTMF
SETTINGS
You can enable DTMF detection and settings in the Advanced section of the
Settings tab.
Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the Settings tab.
3 Click Advanced.
4 In the IP to ISDN Calls section of the PRI Gateway, you can select the
Translate DTMF from IP out-of-band (H.245) to ISDN in-band
(G.711 only) check box.
In the IP to Serial Calls section of the Serial Gateway, you can select the
Translate DTMF from IP out-of-band (H.245) to Serial in-band
(G.711 only) check box.
When selected, the Gateway performs the following:
Converts H.245 out-of-band DTMF signals coming from the H.323
IP-side endpoint to in-band signals on the ISDN side.
Gateway
ISDN or Serial IP
in-band
in-band
Gateway
ISDN or Serial IP
H.245 out-of-
band
in-band
in-band
Duplicate DTMF signal from ISDN or Serial side as out-of-band on IP side
Unchecked
Checked
- SCOPIA 400/1000 Gateway 1
- CONTENTS 3
- Contents v 5
- 4 Using the SCOPIA Gateway 6
- Messaging 7
- ABOUT THIS MANUAL 9
- FUNCTIONALITY 11
- ABOUT GATEWAY 12
- FEATURES 12
- Functionality 3 13
- About Gateway Features 13
- RADVISION Gateways 14
- RADVISION Stack v4.0) 14
- RADVISION unit 15
- ABOUT SCOPIA 17
- GATEWAY 17
- ABOUT MULTIMEDIA 18
- CONFERENCING 18
- POINT-TO-POINT 19
- ABOUT MULTIPOINT 19
- Office Switch 21
- PRI Line 21
- ABOUT C ONFERENCING 23
- LEASED LINES 23
- Functionality 15 25
- ABOUT PEER-TO-PEER 26
- CONNECTIVITY 26
- INSTALLING THE SCOPIA GATEWAY 27
- PHYSICAL 28
- DESCRIPTION 28
- GATEWAY P20 SP 29
- GATEWAY S40 SP 30
- PREPARING FOR 31
- INSTALLATION 31
- ON THE SCOPIA 1000 32
- RADVISION for the 33
- VERIFYING THE 34
- PACKAGE 34
- INSTALLING THE 38
- Installing the Gateway 40
- INITIAL GATEWAY 44
- CONFIGURATION 44
- J1 Male (DB-60) 51
- (M-34 Winchester) 51
- J3 Male (DB-25) 51
- EIA-449 data 52
- EIA-530 data 53
- EIA530/RS366-DTE 54
- J2 Male (DB-25) 55
- DESCRIPTION OF DCE 56
- J2 Female 57
- J3 Female (DB-25) 57
- J2 Female (DB-37) 58
- J2 Female (DB-25) 59
- Signal Name Mnemonic 60
- DATA INTERFACE PIN 62
- Figure 2-17 DB-37 Pin Layout 63
- Figure 2-18 DB-25 Pin Layout 64
- SIGNALING INTERFACE 65
- PIN-OUT 65
- NETSCAPE NAVIGATOR 69
- Registering the Online Help 70
- ONFIGURING THE SCOPIA GATEWAY 71
- VIEWING ADDRESS 78
- Element Description 88
- ABOUT THE 90
- 91
- VIEWING THE 92
- to unregister 97
- Configuring Gateway Settings 100
- PEER-TO-PEER 101
- H.323 CALL 101
- DISCONNECT 101
- Procedure 102
- ABOUT AUDIO 105
- TRANSCODING 105
- COLLABORATION 106
- ABOUT T.120 DATA 106
- CONFIGURING 109
- QUALITY OF SERVICE 109
- GATEWAY EVENT 112
- TRAP SEVERITY 118
- ENUMERATION 118
- ABOUT DTMF 127
- SETTINGS 127
- DETECTION ON 128
- IP-TO-ISDN OR 128
- SERIAL CALLS 128
- ADVANCED 131
- COMMANDS 131
- DCE Common RS-366 142
- ABOUT ADVANCED 145
- ISDN SETTINGS FOR 145
- PRI GATEWAYS 145
- ABOUT NSF 146
- Configuring Port Settings 147
- Octet Function 148
- Bits Feature 150
- NETWORK SPECIFIC 153
- FACILITY SETTINGS 153
- VIEWING CALL 158
- INFORMATION 158
- Field Description 160
- Destination 161
- Importing Configuration Files 166
- USING THE SCOPIA GATEWAY 167
- PREFIXES 168
- ABOUT SECOND 169
- DELIMITERS 169
- ABOUT DIALING IN 170
- THE IP 170
- VIA THE 170
- Routing Method Explanation 171
- ABOUT THE IVR 173
- BOUT DIALING 174
- NDIRECTLY THROUGH AN 174
- TROUBLESHOOTING THE SCOPIA 175
- CHECKING YOUR 176
- Verification Steps 177
- RADVISION Customer Support 178
- RADVISION Customer Support: 178
- RESOLVING 179
- ISDN-TO-IP CALL 179
- FAILURE 181
- RESOLVING ISDN 183
- VIDEO QUALITY 183
- RESOLVING VIDEO 184
- RESOLVING DTMF 185
- CALLER ID ISSUES 186
- USING THE RADVISION AUDIO 187
- UTILITY FOR IVR 187
- MESSAGING 187
- CALL ROUTING 188
- MESSAGES 190
- Playing a Message 191
- 6 Click Upload 197
- Using Express Setup 198
- USING THE RADVISION SOFTWARE 199
- UPGRADE UTILITY 199
- RADVISION device 201
- RADVISION 201
- Upgrading Software 202
- Index 193 203
- Index 195 205
- Index 197 207
Produits connexes et manuels pour Passerelles/contrôleurs RADVision SCOPIA 400
(16 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.045 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels