RADVision SCOPIA 400 Guide de l'utilisateur télécharger pdf (Page 46)

36 SCOPIA 400/1000 Gateway User Guide

Initial Gateway Configuration

 Procedure

1 Connect the supplied terminal cable to the PC terminal.

2 Connect the power cable.

3 Start the terminal emulation application on the PC.

4 Set the communication settings in the terminal emulation

application on the PC as follows:

 Baud rate: 9600

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

5 Turn on the power to the Gateway.

6 After the terminal emulator session starts, press the RST

button on the Gateway front panel to reset the module.

A log of the auto-boot events and a VxWorks banner scrolls

across the computer monitor.

Note When the Gateway is started for the first time, two VxWorks banners

appear. The configuration option appears after the second banner.

7 When the message “Press any key to start configuration”

appears on the screen, press any key within 6 seconds.

The network configuration Main menu displays:

Press any Key To start configuration...

Main menu

Enter <N> to configure default network port values

Enter <P> to change the configuration software password

Enter <A> to display advanced configuration menu

Enter <Q> to quit configuration menu and start GW

Caution If you do not press a key before the countdown ends, the device

continues its initialization and you can only configure the device by pressing

the RST button on the front panel.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 207 208

Pas de commentaire

RADVision SCOPIA 400 Guide de l'utilisateur Page 46