RADVision Scopia XT5000 Series Guide d'installation télécharger pdf (Page 77)

You can also select the country in which the system is located and the language in which the system

menus are displayed.

After initial setup, you can modify these settings by selecting Configure > General from the Main menu,

or from the web interface as described in Remotely Setting the System Name and Language on page

85.

Before you begin

Access the quick setup wizard from the endpoint or web interface, as described in Accessing the Quick

Setup Procedure on page 75.

Procedure

1. Enter the name of the XT Endpoint in the System Name field. This name is also used for the

SIP username and the H.323 name, which can be manually changed.

If you perform this task from the endpoint interface, use the alphanumeric keys of the XT

Remote Control Unit (for more information, see Using the XT Remote Control Unit on page

61).

Figure 44: Setting Country and Language

2. Select the required country from the Country list. If performing this task from the endpoint

interface, use the arrow keys and press ok/menu.

The system menu and the Language field automatically change to the language used in the

selected country.

3. If you want to change the language of the system menus, select Language.

If performing this task from the endpoint interface, press ok/menu to display the list of

languages. Scroll to the preferred language and press ok/menu.

4. To adjust the image on your monitor, select Next and continue with

Adjusting the Image

Position on page 78.

If performing the quick setup from the web interface, access the quick setup from the

endpoint to adjust the image. This can be done at any time.

Installation Guide for Scopia XT5000 Endpoint with Embedded

Server for IP Office Version 3.2

Initial Configuration | 77

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 158 159

Pas de commentaire

RADVision Scopia XT5000 Series Guide d'installation Page 77