RADVision SCOPIA 1000 Guide de l'utilisateur télécharger pdf (Page 71)

'Troubleshooting' | 65

RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0

• Automatically - The installed software fails to start properly for three consecutive times. The

Recovery Mode is automatically invoked. If the user aborts the recovery procedure, theCodec

Unit will try to start again the regular software application.

• User initiated - The user restarts the Codec Unit in Recovery Mode by navigating to

Administrator Settings > password > Utilities > Load default values > Recovery.

Note: iVIEW is the tool used for backing up configuration files. See Importing/Exporting Configuration

Files page 61.

Procedure

Step 1 Once activated, the Recovery Mode screen appears on the display.

Figure 4-4 Initial Screen

The screen indicates whether the Recovery Mode is automatic or user initiated.

It also indicates the personalized Remote Control Code used by the Codec Unit ( default 01). See

the SCOPIA XT1000 User Guide for information on how to personalize the Remote Control Unit.

Verify that the network cable is connected to the GLAN connector (marked 10/100/1000) on the

back panel of the Codec Unit.

Press on the Remote Control Unit and enter a static IP address, or press any key to receive an

IP address dynamically, if a DHCP server is available in the network.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 77 78 79

Pas de commentaire

RADVision SCOPIA 1000 Guide de l'utilisateur Page 71