RADVision Scopia Elite 5100 Series Guide d'installation télécharger pdf (Page 18)

Preparing the MCU Setup | 14

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7

Unpacking the Device

We strongly recommend that you follow safety guidelines described in this section during

unpacking.

Procedure

Step 1

Inspect the shipping box to verify that it is not seriously damaged during shipping.

Step 2 Place the shipping box on a horizontal surface paying attention to the This Side Up symbol on the

shipping box. See Figure 3-1 on page 14.

Figure 3-1 This Side Up symbol

Caution The accessories kit is situated on top of the device inside the shipping box and can be damaged if

the box is placed upside down. Pay attention to the This Side Up symbol on the shipping box to

handle the box correctly at all times.

Warning

To prevent injury and equipment damage, follow lifting guidelines described in the Safety

Guide when lifting or moving the shipping box.

Step 3 Cut the plastic straps.

Caution The plastic straps are tightly stretched and can hit you when you cut them. To avoid this, make sure

you do not face the side of the box secured by the straps before you cut the straps.

Step 4 Cut the strapping tape.

Step 5 Open the shipping box.

Step 6 Take the accessories kit out of the shipping box.

Step 7 Take the device out of the shipping box.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 56 57

Pas de commentaire

RADVision Scopia Elite 5100 Series Guide d'installation Page 18