RADVision Scopia Elite 5100 Series Manuel d'utilisateur télécharger pdf (Page 9)

Assign an IP Address to the MCU 5

8. Enter 2 to change the network configuration.

9. Enter the IP address you want to assign to the MCU at

the Enter IP address for default interface prompt and

press Enter.

Note Do not use leading zeros in the IP address.

10. Enter the IP address of the router associated with the

segment in which the unit will be installed at the Enter

Default Router IP Address prompt and press Enter.

Note Do not use leading zeros in the IP address.

11. Enter the subnet mask without leading zeros at the

Enter IP Mask for default interface prompt and then

press Enter.

To use the default mask of

255.255.0.0 press Enter.

12. Press Enter in the next prompts.

13. Press Y to save the new configuration.

14. Press Q to quit the configuration menu.

15. Allow the unit to complete the reboot process. A new

emulator session begins.

16. Close the terminal emulator session.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

RADVision Scopia Elite 5100 Series Manuel d'utilisateur Page 9